Table of Contents
Advertisement
Home Center Software
Configuring printer settings
KODAK Home Center Software is installed as part of the software installation on
your computer. The Home Center icon is added to your desktop and, depending on
your configuration, to the Start menu. Use this icon to start Home Center Software.
On a computer with WINDOWS Operating System (OS), you can use Home Center
Software to:
• browse, crop, enhance, and edit pictures
• print, scan, and fax
• upgrade your printer with the latest software and firmware
• configure your printer
• order supplies
• access the KODAK Tips and Projects Center
On a computer with MAC OS, you can use Home Center Software to order supplies,
configure your printer, set printer scan settings, or check for printer software
updates.
To set or change basic printer settings:
1. Press Home .
2. Press
to select Printer Settings , then press OK .
3. Press
to select one of the following settings:
• Date and Time
– Press OK , then press
Press
or
NOTE: You can also synchronize the printer date and time to your computer
using Home Center Software.
• Time to Low Power
To conserve energy, the printer will enter a reduced power (sleep) mode
automatically after 1 hour. You can adjust the delay time (in 0.5 hour
increments) up to 4 hours. Increasing the delay time may result in reduced
energy savings.
– Press
to change the time to energy-saving sleep mode (select from 1 to
4 hours in 0.5 hour increments).
• Tagged Images Printing (see
– Press
to select Off or On .
www.kodak.com/go/aiosupport
KODAK ESP 5200 Series All-in-One Printer
to select Year , Month , Day , Hour , or Minute .
to change the values; press OK when you are done.
Printing tagged pictures, page
21)
3
Advertisement
Table of Contents
