Led Mode Select Button And Indicator Leds - HP 2510-24 Installation And Getting Started Manual

Introducing the Switch
Front of the Switch
Switch LEDs State
LED Mode Act
View (3 green
FDx
LEDs)
Spd
* The blinking behavior is an on/off cycle once every 1.6 seconds, approximately.
** The blinking behavior is an on/off cycle once every 0.8 seconds, approximately.

LED Mode Select Button and Indicator LEDs

To optimize the amount of information displayed for each of the switch ports
without overwhelming you with LEDs, the Series 2510 Switch uses two LEDs
for each port. The operation of these LEDs is controlled by the LED Mode
select button, and the current setting is indicated by the LED Mode indicator
LEDs near the button. Press the button to step from one view mode to the next.
■
■
1-4
Meaning
Indicates the port LEDs are displaying network activity information.
Indicates port LEDs are lit for ports in Full Duplex Mode. Off indicates half duplex.
Indicates port Mode LEDs are displaying the connection speed of each port.
• if the port LED is off, the port is operating at 10 Mbps.
• if the port LED is blinking **, the port is operating at 100 Mbps.
• if the port LED is on continously, the port is operating at 1000 Mbps.
(two for each port)
Link and Mode
*
Spd mode:
ProCurve Switch
1
Link Mode
2510-24
J9019A
Power
Fault
Act
Locator LED
Mode
FDx
Test * Spd
Link 2
Reset Clear Mode
Console
Each port has a Link LED. If it is lit, the port has a link. If the Link LED is
blinking, the port has failed its self test. The Fault and Test LEDs will be
blinking simultaneously.
If the Activity (Act) indicator LED is lit, each port LED displays activity
information for the associated port—it flickers as network traffic is
received and transmitted through the port.
Port LEDs
off = 10 Mbps, flash = 100 Mbps, on = 1000 Mbps
3 5 7 9 11
4 6 8 10 12
LED Mode select button
and indicator LEDs
ProCurve Switch 2510-24
10/100Base-T Ports (1 - 24) — Ports are HP Auto MDI-X
13 15 17 19
Link Mode
Link 14 16 18 20
Mode