Wall Mounting; Connect The Switch To A Power Source - HP 2510-24 Installation And Getting Started Manual

Wall Mounting

C a u t i o n
The switch can only be mounted with the RJ-45 ports facing up.
1.
2.

5. Connect the Switch to a Power Source

1.
2.
Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.
Attach the switch to the wall or wood surface with two 5/8-inch number
12 wood screws (not included).
Wall
M4 screws
Plug the included power cord into the switch's power connector and into
a nearby AC power source.
Re-check the LEDs during self test. See "LED Behavior" on
RJ-45 Ports
5/8-inch
wood screws
Installing the Switch
Installation Procedures
page 2-10
2-15