Table of Contents
Advertisement
1-4
10. Never attempt to operate the power supply in any manner not described in this manual.
11. Never remove DANGER and WARNING labels from the power supply. Replace lost or
damaged labels immediately.
12. The power supply should only be serviced by TDK-Lambda Americas factory authorized
personnel.
13. No user maintenance is required.
14. No cleaning is required.
1.7
SCOPE OF THIS MANUAL
This manual is used for installing and operating the 203 and 303 Series 2 Power Supply
with a revised front panel layout shown in Figure 4-1. For older model 303 supplies refer
to manual part number 83489009 which can be found on our web site. Suggestions and
requirements for connecting AC power, load cables and signal cables are given. Various
operating modes and programming modes are described.
1.8
MODEL NUMBER FORMAT
The model numbering system for the 203 and 303 Series power supply includes sym-
bols for features and options. They are separated by dashes.
Examples are: 303L-10kV-POS-400VAC and 203S-20kV-POS-DC.
The 203 and 303 are available with two basic front panel configurations, the L, and S.
The choice of panel configuration is dependent upon the installation and system re-
quirements. See section 5 for further details.
Table 1-1 shows a partial listing of the model description format for the 203/303 Power
Supply family. For additional options, the customer may contact the Sales Department
at TDK-Lambda Americas. Special options are typically shown as a four-digit suffix to
the model number.
GENERAL INFORMATION
83489011 Rev A
Advertisement
Table of Contents
