Miele HR 1421 Installation Instructions Manual page 69

2
1
3
Attaching to the floor
3
2
1
Attaching to the wall
a Anti-tip device
b Screws
c Locking nut
 Secure the anti-tip device  to the
floor surface with suitable bearing
capacity, either to the floor or wall.
using four screws .
 Screw the locking nut  to the bolt,
see the "Installation dimensions of
locking bolt" table.
Do not push the range into
position until all the utility
connections have been made.
The toe-kick cover is attached to the
base of the range by magnets.
1 2
a Toe-kick cover
b Locking clamp
 Remove the toe-kick cover  from
the appliance.
 Pull out the locking clamp .
The locking clamp extends through
the toe-kick plate of the range
housing. Its length is approximately
equal to the depth of the range.
A slot is located in the non-visible rear
section of the locking clamp. This slot
will engage with the bolt of the anti-tip
device when you slide the locking
latch into the range.
Anti-tip device
69