Replacing The Idtemp Combo - Fujitsu PRIMERGY RX300 S5 Service Supplement Manual

Replacement routines

Replacing the IDTemp Combo

4.7 Replacing the IDTemp Combo
This board includes two important system components:
– EEPROM for the chassis ID and Ident number of the server
– temperature sensor for monitoring the environmental temperature
The data for the EEPROM, and the current temperature values as well, are
2
transmitted to the system board via the connected I C bus.
The IDTEMP combo must be correctly installed in order to monitor the temper-
ature correctly, enable ServerView to display the correct system picture and to
install the server using ServerStart.
Ê Open the server as described in the section "Preparation" on page 17.
Ê Remove the fan box (see Option Guide PRIMERGY RX300 S5 in the
chapter „preparations").
Figure 30: Removing IDTemp Combo with holder
Service Supplement 41
RX300 S5