Fujitsu PRIMERGY RX300 S5 Service Supplement Manual page 12

Safety notes
V
CAUTION!
● Ensure that the power socket on the device or the grounded wall
outlet is freely accessible.
The ON/OFF button does not disconnect the device from the mains
●
voltage. To disconnect the line voltage completely, remove all power
plugs from the grounded insulated sockets.
Always connect the device and the attached peripherals to the same
●
power circuit. Otherwise you run the risk of losing data if, for example,
the central processing unit is still running but the peripheral device
(e.g. storage subsystem) has failed during a power outage.
Data cables to peripheral devices must be adequately shielded.
●
To the LAN wiring the requirements apply in accordance with the
●
standards EN 50173 and EN 50174-1/2. As minimum requirement
the use of a protected LAN line of category 5 for 10/100 Mbit/s
Ethernet, and/or of category 5e for Gigabit Ethernet is considered.
The requirements of the specification ISO/IEC 11801 are to be
considered.
Route the cables in such a way that they do not form a potential
●
hazard (make sure no-one can trip over them) and that they cannot
be damaged. When connecting up a device, refer to the relevant
notes in this manual.
Never connect or disconnect data transmission lines during a storm
●
(lightning hazard).
● Make sure that no objects (such as bracelets or paper clips) fall into
or liquids spill into the device (risk of electric shock or short circuit).
In emergencies (e.g. damaged casing, controls or cables, penetration
●
of liquids or foreign matter), switch off the device immediately, remove
the power plug and contact your sales outlet or customer service
team.
Proper operation of the device (in accordance with IEC 60950/
●
EN 60950) is only ensured if the casing is completely assembled and
the rear covers for the installation openings have been put in place
(electric shock, cooling, fire protection, interference suppression).
12 Service Supplement
RX300 S5