Table of Contents
Advertisement
Replacement routines
Replacing the IDTEMP combo
Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
4.8
Replacing the IDTEMP combo
This board includes two important system components:
– EEPROM for the chassis ID and ident number of the server
– temperature sensor for monitoring the environment temperature
The current temperature values and EEPROM data are transmitted to the
2
system board via the connected I
C bus.
The IDTEMP combo must be correctly installed in order:
– to monitor the temperature correctly,
– to enable the server management to display the correct system picture,
– to install the server using ServerStart.
The IDTEMP combo is situated on a separate holder under the hard disk cage.
Ê Open the server as described in the
section "Preparation" on page
17.
Figure 11: Removing the holder
Ê Push the holder in direction of the arrow.
Service Supplement
29
TX150 S5
Advertisement
Table of Contents
