Table of Contents
Advertisement
GS-SR222 System Installation Guide
5.3. Heat Sink Installation
Step 1. Put the Heat sink on the CPU.
Figure 8
Step 2. There are for screws hold the retention modules. Seat the
heat sink firmly in the retention modules with the two cooler
brackets.
Step 3. First, hook one end of the cooler bracket to the CPU
socket as shown in the Fig-8. Make sure the middle part of
bracket is push into the desired position. (Fig-9)
Step 5. Hook the other end of the cooler bracket by gripping it to
another side of retention module. (Fig-10)
14
Figure 9
Figure 10
Advertisement
Table of Contents
