Table of Contents
Advertisement
GS-SR222 System Installation Guide
Step 3. Carefully pull up and remove the PCI riser bracket. (Fig-
17).
Figure 17
Step 4. Install the card into place. There are two standoff copper
pillars to hold the raiser card. Secure the card with screw. Make
sure it is seated properly into PCI slot.
Step 5. Replace the riser bracket into the PCI slot on the
motherboard (Fig-18)
Figure 18
Figure 19
Step 6. Push down the bracket firmly. The card is seated properly
into PCI slot. (Fig-19)
17
Advertisement
Table of Contents
