Dual Inline Memory Modules - Compaq ProLiant ML570 Maintenance And Service Manual

Dual Inline Memory Modules

To remove an SDRAM DIMM:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the access panel. See "Access Panel (Tower and Rack)" earlier in this chapter.
3. Remove the memory expansion board. See "Memory Expansion Board" earlier in
this chapter. Set the board on a sturdy nonconductive surface.
4. Pull both SDRAM DIMM socket latches
the DIMM socket.
5. Lift out the SDRAM DIMM
Figure 2-30. Removing an SDRAM DIMM (expansion board removed for clarity)
Reverse steps 1 through 5 to replace an SDRAM DIMM.
IMPORTANT: A memory module can be installed only one way. Be sure to match the two key sockets on
the module with the two tabs on the memory socket. Push the module down into the socket, ensuring
that the module is fully inserted and properly seated.


.

1
2
Removal and Replacement Procedures 2-39
outward to release the SDRAM DIMM from
1