Figure 7-3 Scsi Tray Removal And Replacement - Sun Microsystems Ultra Enterprise 3000 System Manual

7
Notch
Captive screws (2)
7-4
2. Loosen the bottom two captive screws that secure the SCSI tray to the
chassis tray.
See Figure 7-3.
3. Use a screwdriver in the notch at the bottom center of the tray to assist in
separating the SCSI tray from the rear slip connectors. Remove the
devices with the tray.
Figure 7-3 SCSI Tray Removal and Replacement
4. To access the devices in the SCSI tray, remove the seven screws on top of
the tray and remove the top panel.
To remove and replace an existing device, perform Step 5. To install a tape
drive for the first time, proceed to Step 6.
Ultra Enterprise 3000 System Manual—November 1996