Table of Contents
Advertisement
Electrical
This appliance must be supplied with a 220 – 240 V, 50 Hz, sinusoidal, 10 A electrical
supply.
Draining
Regularly check that your standpipe or tub is free from lint or other obstructions, which
●
●
may affect how your machine works or may cause flooding.
In multi-storey apartments or any upper floor, the machine should be installed on a floor
●
●
equipped with a drain.
Draining must comply with local by-laws.
●
●
Water supply
Your cold water should not exceed 35°C and your hot water should not exceed 65°C.
●
●
Temperatures above these may cause the machine to fault or cause damage to the
machine.
If you have an uncontrolled water heating source (eg a wet back or solar heating
●
●
system) you should fit a Safe Valve. This will ensure the hot water temperature remains
within safe limits.
Inlet water static pressure: Max.1 MPa (150 psi) Min. 34 KPa (5 psi)
●
●
Inlet water flow rate at tap: Min. 6 litres/min
●
●
HOT 'N' SAFE VALVES AVAILABLE ARE:
RMC TVA 50HF
RMC TVA 75HFS
Adjustable between 35°C – 55°C
RMC TVA 50HP
For instantaneous gas hot water supply
INSTALLATION INSTRUCTIONS
7
Hide quick links:
Advertisement
Table of Contents
