Table of Contents
Advertisement
Completing your installation
Turn on the water and check all hose connections for leaks. Make sure there are no kinks
●
●
in the hoses. Check the hose connections for leaks again after 24 hours.
Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.
●
●
Installation test cycle
Your washer must be correctly installed before use. Check the installation and operation
of the machine using the following procedure:
Touch
to activate your washer.
1
Touch both the
2
Touch
to start the installation test cycle.
3
The machine will beep to signal the end of the installation test cycle. Any faults will be
4
displayed on the screen (refer to the back of this user guide to help identify faults). If you
need further assistance, please contact a Fisher & Paykel Customer Care Representative.
Refer to page 44 for contact details.
Note: if there are no faults found, the washer will automatically turn off at the end of the
installation test cycle.
ACCESSORIES AND SPARE PARTS
Available from your Fisher & Paykel dealer or a Fisher & Paykel Authorised Repairer.
Inlet Valve Cap
Hose Inlet Long (2 m)
Hose Inlet Large Bore
Drain Hose Extension
Power Cord
10
INSTALLATION INSTRUCTIONS
and 'Options' buttons at the same time, and hold for three seconds.
Part No. 388491P
Part No. 422680P
Part No. 426123P
Part No. 425627P
If the power cord of your clothes washer is damaged it must
be replaced by a Fisher & Paykel Authorised Repairer in
order to avoid a hazard, as it is not a standard power cord.
Hide quick links:
Advertisement
Table of Contents
