Table of Contents
Advertisement
Unpacking
To ensure the best performance from your new washer please follow the instructions below.
Removing the packaging
Remove the outer packaging.
1
Tilt the machine backwards and walk it off the
2
base packer one foot at a time (ensure the lid
is still taped down).
Remove the base packer from under the
3
machine by tilting the machine backwards and
pulling the packer out the front.
Remove the tape, lift the lid and remove the
4
bowl packer from the bowl.
Remove the hoses and accessories.
5
Keep the base packer and bowl packer in case
6
they are required for future transit.
ImpORTANT!
Please ensure that the base packer has been removed BEFORE OPERATINg your
machine.
Location
Your washer must be installed on a level surface and not on any textured floor coverings
(eg carpet, rugs) to ensure that the opening at the bottom of the machine is not
obstructed.
In your clothes washer you will find:
1 hose guide.
●
●
2 inlet hoses.
●
●
Drain hose
Carefully pull the drain hose out from the back
1
of the machine by pulling the exposed part of
the hose downward and outward.
To guide the drain hose over the tub or
2
standpipe the hose guide MUST be fitted to the
drain hose.
ImpORTANT!
To prevent siphoning the drain hose should
not extend more than 20 mm from the end of
the guide. The height of the standpipe or tub
should be between 850 – 2400 mm. The drain
hose can be trimmed to length.
Place the drain hose in the tub or standpipe. Do
3
not fit the hose to a drain spigot. Drainage must
not be airtight in order to prevent siphoning.
6
INSTALLATION INSTRUCTIONS
Tilt washer backwards to remove packer
Pull hose
through
guide
Flex hose
guide apart
Fitting the drain hose guide
(20 mm)
maximum
Hide quick links:
Advertisement
Table of Contents
