Advertisement
I N S TA L L AT I O N & U S E R I N S T R U C T I O N S
Section Contents
1.0
Preliminary Notes
2.0
Appliance Data
3.0
Installation Requirements
4.0
Unpacking The Appliance
5.0
Component Checklist
6.0
Installing The Appliance
1.0 PRELIMINARY NOTES
The appliance is designed for indoor use, and can be simply floor mounted in the majority of floor positions anticipated. It can be located in any
household room, with the exception of bathrooms. Read all of the instructions before commencing installation. Retain for future reference and
pass on as necessary to subsequent owners of the appliance.
DO NOT
•
use this appliance immediately below a fixed socket outlet.
DO NOT
•
use this appliance in an open flue.
DO NOT
•
use this appliance in the immediate vicinity of a bath, shower, swimming pool or other area where water/moisture could pres-
ent a hazard.
CAUTION
: This appliance must not be used in conjunction with any timer, programmer or thermal control, or any other device that
•
will switch on the appliance automatically, as a fire risk may occur if the heaters are accidentally covered or displaced.
CAUTION
: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and
•
vunerable people are present.
WARNING
•
: Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and less
than 8 years shall only switch on/off the applaince provided that it has been placed or installed in its intended normal operating position and
they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged
from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
WARNING
: This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when
•
they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
Do not allow the heater to be covered as this may cause overheating. The appliance must not be placed near curtains or similar material. A
clearance space of at least one metre should be allowed in front of the appliance.
The electrical socket that the appliance uses MUST be easily accessible. Do not route the supply cord directly over or above the heater unit. If
the cord is damaged, it must be replaced by a service agent or competent person.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
2.0 APPLIANCE DATA
Weight (kg):
Voltage (Volts):
Rated Power
Supply Plug:
Supply Cord:
Location:
LED Display:
3.0 INSTALLATION REQUIREMENTS
The appliance is suitable for installation into all proprietary surrounds with an opening of 406mm by 559mm (16" by 22").The appliance is sup-
plied fitted with 2 spacer frames enabling it to be fitted with no need for a recess into a wall or surround back panel. Both spacer frames have
a depth of 57mm. The appliance can be fully recessed if the opening depth is 113mm or greater and neither spacer is used. It may be installed
directly into any proprietary surround which can house this size of rebate, without the need to recess the appliance into a wall opening or fab-
ricate a false chimney breast.
This appliance should be positioned on a firm level surface and in a clean 'dust free' environment. If the fire is to be sited in a fire surround then
the suitability of the surround for use with electrical heaters should be established with the fire surround manufacturer.
If fitted into an open draught fireplace, it is recommended to blank off the chimney to reduce the risk of draught through the fire, which may
cause the safety cut out system in the fan heater to operate.
Page No.
Section Contents
2
7.0
Removing the appliance spacer frames
2
8.0
Fitting The Decorative Frame And Front 5
2
8.1
Fitting The Loose Fuel Bed Options
3
9.0
Operating the Appliance
3
10.0
Safety Cut-Out System
3
11.0
Cleaning And Maintenance
12.0
Guarantee - Terms And Conditions
14 kg
220-240V a.c. 50Hz
2 x 900W/ 2 x 1000W
BS 1363, 13A Fused
1.7 Metres
Indoor Use
25 Watts
2
GB IE
Page No.
4
5
6
6
6
7
2014 Focal Point Fires plc.
'
Advertisement
