Using Remote Management; Using Express Scan; Step 1: Create Barcodes - LXE MX3X Reference Manual

Using Remote Management

Using Remote Management
For Your MX3X
1. Configure the radio to connect to the network running the Mobile Device Server. After the MX3X is connected, proceed
to step 2.
2. If it is desired to configure the radio using the Cisco or Summit package, add the configured package to the Wavelink
Avalanche MC Console and enable it.
3. Verify RMU.CE.CAB exists in the \System\RMU folder.
4. Double click the MX3X enabler CAB file in the \System folder.
5. The enabler automatically launches after installation and contacts the Mobile Device Server. The Avalanche MC Con-
sole connected to that Mobile Device Server identifies the remote device and performs a sync. This downloads any
available packages available for the MX3X.

Using eXpress Scan

MX3X eXpress Scan Desktop Icon
If the MX3X has an eXpress Scan icon on the desktop, eXpress Scan may be used for the initial configuration of the device.
If the eXpress Scan icon is not present on the desktop, install the Enabler following the instructions earlier in this section. If the
icon is still not present, the Enabler must be updated as detailed in the installation instructions earlier in this section.
If the eXpress Scan icon is present, follow these steps to configure the MX3X to connect with the wireless network and the
Mobile Device Server.

Step 1: Create Barcodes

Barcodes are created with the eXpress Config utility on the desktop/laptop computer, not the mobile device. Depending on the
barcode length and the number of parameters selected, eXpress Config generates one or more barcodes for device
configuration. The barcodes contain configuration parameters for the wireless client in the LXE device and may also specify
the address of the Mobile Device Server.
Barcodes should be printed at a minimum of 600 dpi.
See "Creating Configuration Barcodes with eXpress Config"
E-EQ-MX3XRG-W-ARC [ 173 ] MX3X Reference Guide