Table of Contents
Advertisement
Installation
3.6.
Antenna/Radome Installation
Connect and secure the Antenna M&C Coax to the
M&C connector (Black Heat Shrink) at the base of
the radome.
Referring to the System Block Diagram for color
code callouts, connect and secure the IF Coaxes
from below decks to the connector bracket at the
base of the radome.
Apply Loctite™ thread locker to the four M8
Mounting Studs. Using the provided L-Key, install
and secure the studs onto the deck mounting
adapters located at the base of the radome.
Carefully place radome onto mounting location, be
careful not to pinch coaxes in between radome
and mounting surface.
3.5.3.2.
DC Power Cable (All Models)
3.5.3.2.1.
Supply to GACP
Route the DC Power cable assembly from the Vessel Power Source to the GACP mounting
location.
3.5.3.2.2.
Supply to Optional Power Switch
Perform the following step only if installing the optional power switch.
Route the DC Power cable assembly from the Vessel Power Source to the Optional Power
Switch mounting location.
Continue routing the remaining wires from the Optional Power Switch mounting location
to the GACP mounting location.
3-8
ST24 Ku-Band TVRO
Hide quick links:
Advertisement
Table of Contents
