NETGEAR GS748T Software Administration Manual page 186

To create an Access Profile:
1. In the Access Profile Name field, specify the name of the access profile to be added.
The maximum length is 15 characters.
2. To activate an access profile, select the Activate Profile check box. You cannot add rules to
an active profile.
3. To deactivate an access profile, select the Deactivate Profile check box.
4. To remove an access profile, select the Remove Profile check box. The access profile
should be deactivated before removing the access profile.
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
6. If you make changes to the page, click Apply to apply the changes to the system.
The Profile Summary table shows the rules that are configured for the profile, as the following
table describes.
Field
Rule Type
Service Type
Source IP Address
Mask
Priority
Click Refresh to update the page with the most current information.
GS748T Smart Switch
Description
Identifies the action the rule takes, which is either Permit or Deny.
Displays the type of service to allow or prohibit from accessing the switch
management interface:
• SNMP
• HTTP
• HTTPS
Displays the IP Address of the client that may or may not originate
management traffic.
Displays the subnet mask associated with the IP address.
Displays the priority of the rule. The rules are validated against the incoming
management request in the ascending order of their priorities. If a rule
matches, action is performed and subsequent rules below are ignored.
186