Switch Discovery In A Network Without A Dhcp Server - NETGEAR GS748T Software Administration Manual

Switch Discovery in a Network without a DHCP Server

This section describes how to use the Smart Control Center to set up your switch in a
network without a DHCP server. If your network has no DHCP service, you must assign a
static IP address to your switch. If you choose, you can assign it a static IP address, even if
your network has DHCP service.
To assign a static IP address:
1. Connect the switch to your existing network.
2. Power on the switch by connecting its power cord.
3. Install the Smart Control Center on your computer.
4. Start the Smart Control Center.
5. Click Discover for the Smart Control Center to find your GS748T switch. The utility
broadcasts Layer 2 discovery packets within the broadcast domain to discover the switch.
You should see a screen similar to
6. Select the switch, then click Configure Device. The page expands to display additional
fields at the bottom of the page, as the following figure shows.
.
7. Choose the Disabled radio button to disable DHCP.
GS748T Smart Switch
Figure 1 on page 12.
14