Multicast Router Vlan Configuration - NETGEAR GS748T Software Administration Manual

Multicast Router VLAN Configuration

This page configures the interface to only forward the snooped IGMP packets that come from
the specified VLAN to the multicast router attached to this interface. The configuration is not
needed most of the time since the switch will automatically detect the presence of a multicast
router and forward IGMP packets accordingly. It is only needed when you want to make sure
that the multicast router always receives IGMP packets from the switch in a complex network.
To access the Multicast Router VLAN Configuration page, click Switching
Snooping Multicast Router VLAN Configuration.

To configure the multicast router VLAN settings:
1. Select the check box associated with each interface you want to configure. Select the
check box in the heading row to apply the same settings to all interfaces.
2. Use VLAN ID to select the VLAN ID for which the Multicast Router Mode is to be Enabled or
Disabled.
3. Use Multicast Router to enable or disable multicast router for the VLAN ID.
4. Click APPLY to update the switch with the changes.
5. Click CANCEL to abandon the changes.
GS748T Smart Switch
120
Multicast IGMP
 