Modern Fan Co Altus Installation Instructions

Advertisement

Altus Fan

- Installation instructions

Should you have any questions or difficulty installing your new fan,
please contact Modern Fan Co. customer service immediately.
Note: Power supply must be turned off prior to any contact with electrical wires.
It is recommended that a licensed electrician be hired to install your ceiling fan.
(1) Remove and identify contents of carton.
blades
fan body
rotor
hardware
package
(2) Using the existing screws from your junction box,
or the machine screws from the hardware package,
secure the hanging bracket to the ceiling junction box.
(3) Remove the stopper screw and loosen the set
screw on the fan collar. Set the stopper screw aside
for step (5).
stopper screw
set screw
Altus
optional control
down rods
half ball
MODERN FAN COMPANY
Customer Service
M-F 8am - 4pm (PST)
(ph) 888.588.3267
www.modernfan.com
balancing kit
hanging
bracket
canopy
bottom cap

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Altus and is the answer not in the manual?

Questions and answers

Summary of Contents for Modern Fan Co Altus

  • Page 1 - Installation instructions Should you have any questions or difficulty installing your new fan, please contact Modern Fan Co. customer service immediately. Note: Power supply must be turned off prior to any contact with electrical wires. It is recommended that a licensed electrician be hired to install your ceiling fan.
  • Page 2 (4) Remove stopper pin and half ball from small down rod by loosening set screw on half ball. Set all parts aside for steps (5) and (7). stopper pin set screw (5) Run fan wires through selected down rod. Reinstall stopper screw from step (3) and firmly tighten set screw on fan collar against down rod.
  • Page 3 (12) Install rotor using the four rotor screws from step (11). Be sure screw tabs on rotor are properly aligned with correct holes on motor. (13) Install bottom cap by rotating in the clockwise direction, or if using the optional light, proceed to step (14).

Table of Contents