Connections; Video Cameras; Video Monitors; Remote Controls - Sony HSR-1 Operating Instructions Manual

Connections

Video Cameras

Number of cameras
In the standard HSR-1/1P/2/2P configuration, up to 4
camera can be connected.
By mounting the optional HSRA-11 input boards
(max. 3 boards), 4 inputs per board can be added; thus,
a maximum of 16 cameras can be connected to the
recorder.
For mounting the HSRA-11, refer to the instruction manual
for the HSRA-11.
Input signals and level from cameras
VBS or VS signal: 1.0 Vp-p, 75 ohms, unbalanced

Video Monitors

The number of monitors
Monitors can be connected to two BNC-type
connectors and one S connectors.
The monitors connected to the BNC connectors can
display different pictures.
Output signals and level to monitors
VBS signal: 1.0 Vp-p, 75 ohms, unbalanced (VIDEO
OUT)
Y signal: 1.0 Vp-p, 75 ohms, unbalanced (S-VIDEO)
C signal: 0.28 Vp-p (HSR-1/2) or 0.30 Vp-p (HSR-
1P/2P), 75 ohms, unbalanced (S-VIDEO)
Connections and
Preparations

Remote Controls

The recorder has a PARALLEL I/O and an RS-232C
connector on the rear and a CONTROL-S connector
on the front for control from external devices.
PARALLEL I/O connector
For 24 input pins and 8 output pins of this 37-pin D-
sub connector, you can assign various functions as
required, such as input/output for alarm recording and
command inputs for tape transport control.
The assignment is made using the Remote Control
menu.
For the functions that can be assigned, see "Remote Control
Menu" on pate 4-13.
Use the supplied multi connector for connection.
RS-232C connector
Using this 9-pin D-sub connector, you can control the
recorder from a computer via an RS-232C interface.
CONTROL-S connector
To this stereo mini jack, you can connect the SVRM-
100A remote control unit.
Chapter
Chapter 5 Connections and Preparations
5
5-1