Rear Panel - Sony HSR-1 Operating Instructions Manual

Rear Panel

OFF
75Ω
1 VIDEO IN (video input) connectors (BNC type)
and 75-ohm termination switches
For connecting video cameras.
Connectors 1 to 4 are provided as the standard inputs.
Connectors 5 to 16 can be added, four additionally
connectors for each optional HSRA-11 input board
mounted.
The termination switches are normally used in the ON
position.
For mounting an input board, see the instruction manual for
the HSRA-11.
2 VIDEO OUT (video output) connectors
S VIDEO (luminance/chroma signal output)
connector (4-pin): Outputs Y/C-separated S video
signals. Connect via a cable to the S video input of
a video monitor.
A (A image output) connector (BNC type): Outputs
composite video signals for monitoring. Character
signals are superimposed on the output signal
depending on the settings made on the Indication
Control menu (page 4-8).
B (B image output) connector (BNC type): Outputs
composite video signals. The signal to be output is
normally the same as that from the A connector.
The Image Control menu (page 4-6) permits you to
specify use of this output exclusively for a specific
camera. Note that the character signal is not
superimposed with such usage.
1 VIDEO IN connectors and 75-ohm termination switches
2 VIDEO OUT connectors
VIDEO IN VIDEO OUT
S VIDEO
13 9 5 1
14 10 6 2 A
B
15 11 7 3
16 12 8 4
PARALLEL I/O
ON OFF ON OFF ON OFF ON
75Ω 75Ω 75Ω
4 PARALLEL I/O connector
3 POWER switch
POWER
OFF ON
⁄AC IN
RS-232C
6 AC IN connector
5 RS-232C connector
3 POWER switch
For turning on/off the power to the recorder.
4 PARALLEL I/O connector (37-pin)
Used to input/output various control signals or to
supply control voltages.
You can use 24 pins for inputs and 8 pins for outputs.
The functions of these pins can be assigned from the
Remote Control menu (page 4-13).
5 RS-232C connector (9-pin)
Connect an editor or computer, via an RS-232C cable.
6 AC IN connector
Connect an AC power source via the supplied AC
power cord.
1-9
Chapter 1 Overview