Sony HSR-1 Operating Instructions Manual page 60

Menu Items
Display
Layer 2 Layer 3 Layer 4
PARALLEL INm MENU
INPUT (n PIN)
SET/YES
(continued) (continued)
RESET/NO
B
b
v
V
PARALLEL OUTPUT
OUTm (n PIN)
NO USE
STOP
REC
PLAY
F.FWD
REW
SERIES REC
TIME
ADJUSTMENT
ALARM
RETURN
ALARM
TAPE END
TAPE EXIST
ERROR
VIDEO LOSS
PRE END
PARALLEL OUT VOLTAGE
OUTm (n PIN)
OPEN
5V
12V
4-14
Chapter 4 Menu Operations
Char. display Contents
>>>Menu
Function the same as those on the menu operation block on the
front panel.
>>>Set/Yes
>>>Reset/No
>>>Left
>>>Right
>>>Down
>>>Up
>ParaOutput For assigning a function to each output pin (8 outputs) of the
PARALLEL I/O connector on the rear panel.
>>n PIN m = 1 to 8, n = pin number 15 to 18, 33 to 36
Outputs no signal.
>>>No use
>>>Stop St Outputs status signals to indicate the operating statuses of the
recorder.
>>>Rec St
>>>Play St
>>>FFWD St
>>>REW St
>>>SeriesRec Outputs the Series-recording signal.
>>>Time Set Outputs the clock set signal when the internal clock counts 00
minute 00 second.
>>>AlmRetrn Outputs a signal upon return from alarm recording
Outputs a status signal to indicate that alarm recording is in
>>>Alarm
progress.
>>>Tape End Outputs a signal when tape end is reached during
recording.
>>>TapeExst Outputs a signal when a cassette is in the recorder.
>>>Error Outputs a signal when an error occurs in the recorder.
>>>Videolos Outputs a signal when the video input from a camera set to
"CONNECT" is lost.
Outputs a signal when the tape remaining becomes less than 3
>>>Pre-end
minutes based on the tape length.
>POutVolt For setting the output voltage from each output pin (8 outputs)
of the PARALLEL I/O connector on the rear panel.
>>n PIN m = 1 to 8, n = pin number 15 to 18, 33 to 36
>>>Open Outputs with OPEN/0 V.
Outputs with 5 V.
>>>5V
>>>12V Outputs with 12 V.