Loop-Back Test Push Button; Pressing Button To Restore Factory Default Settings - KTI Networks KGC-320 Installation Manual

FE_SFP

2.7 Loop-back Test Push Button

The push button is used to perform loop-back test between two media converters connected with fiber cable as
shown below:
It allows installer to perform diagnostic to the fiber link during installation and check the test result displayed
on the LED indicators.

2.7.1 Pressing Button to Restore Factory Default Settings

The button may also be used to restore the software configuration settings to factory default values. The
operations are:
Operations
Press the button and release in normal operation
Press the button about 5 seconds when power up
No 100Mbps Full 100BASE-FX
Functions
Perform loop-back test over fiber cable
Restore factory default settings
-18-