Advertisement
The following instructions describe the installation process for a point-to-point installation. The procedure
is similar for compatible HDBaseT components. In the event a compatible HDBaseT product cannot
provide power over the HDBaseT cable connection, the DIGI-HDX product will require a local power supply.
1.
Verify all components included with the extender set are present before installation.
2.
If the extenders are going to be permanently mounted to a surface, attach the included
mounting brackets with the supplied screws.
3.
Turn off power and disconnect the audio/video equipment by following the manufacturer's
instructions.
4.
Connect shieleded Category 5e or greater twisted pair cable with RJ45 connectors between
the transmitter (DIGI-HDX-S) and the receiver (DIGI-HDX-R). TIA/EIA-568B straight-through wiring
connections must be used with all HDBaseT extenders.
5.
Connect an HDMI cable and any desired control accessories between the display and the
receiver (DIGI-HDX-R).
6.
Connect an HDMI cable and any desired control accessories between the source and the
transmitter (DIGI-HDX-S).
7.
Connect the power supply (PS-24D-25, sold separately) to the transmitter or receiver and lock
the power supply to the power connector by twisting the locking collar clockwise.
8.
Power on attached audio/video devices.
RS232 Wiring
Connect the controller or device RXD signal
to Tx on the DIGI-HDXextender. Connect the
controller or device TXD signal to Rx on the
DIGI-HDX extender.
Diagnostic LEDs:
The DIGI-HDX provides four LEDs to indicate the current operating status and to assist troubleshooting an
installation.
Power: Solid, the DIGI-HDX extender is receiving power from the power supply or from the remote extender via
shielded Category 5e or greater cabling.
Heartbeat: Flashes once per second, the HDBaseT processor is running.
Link: Solid, the two DIGI-HDX extenders are communicating via shielded Category 5e or greater cabling.
HDMI: Solid, HDCP signal is present in the HDMI stream. Flashes quickly, no HDCP signal is present in the HDMI
stream.
Instructions
DIGI-HDX-S or
DIGI-HDX-R
Tx
Rx
Controller or
Device
RXD
GND
TXD
Advertisement
