DIGI-HD-XR Installation Manual
The Intelix DIGI-HD-XR transmits HDMI and IR up to 300' over
one or two twisted pair cables (depending on installation). In
environments with high electromagnetic interference (EMI),
shielded twisted pair cables should be used.
Built-in HDshāk® technology provides dynamic HDMI,
EDID/DDC
and
HDCP
mode
performance and image quality.
The DIGI-HD-XR features electrostatic discharge (ESD)
protection circuitry which safegaurds the HDMI circuit against
static electricity and other destructive stray voltage.
selection,
guaranteeing
8001 Terrace Ave
Suite #201
Middleton, WI 53562
Maximum Recommended Distances
1080p
1080i
Shielded
150'
300'
Cat 6a
Cat 6
110'
220'
Cat 5e
100'
200'
Important notice:
Do not attempt to disassemble or alter the extender
housing. There are no user-serviceable parts inside the
unit. Doing so will void your warranty.
To minimize the possibility of equipment damage from
electrostatic discharge (ESD), all source and destination
equipment must be powered off during installation.
Do not connect the extender to a telecommunication outlet
wired to unrelated equipment. Doing so may damage the
unit or any connected equipment. Ensure all connected
twisted pair cabling is straight-through (point-to-point).
Allow proper ventilation to reduce the risk of thermal
failure.
720p
576i/p
480i/p
300'
300'
300'
220'
220'
220'
200'
200'
200'
Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833