Removal And Re-Installation Of Modules; Refurbishment Services - Meazura MEZ1000 User Manual

· If the terminals of the battery become dirty, wipe them with a dry cloth before using the battery.
· The battery can be stored within a -20°C to 40°C temperature range.
Battery Charging
The lithium-ion battery can provide between 300-500 charge/discharge cycles.
The lithium-ion battery is certainly different from most other rechargeable batteries as charging from
a partially charged battery keeps the battery in great condition whereas other batteries prefer to be
fully discharged each time before recharging again. Fully discharging the lithium-ion battery should
be avoided wherever possible. For most users, charging the battery at the end of each day would be
the ideal choice.
The lithium-ion battery pack typically lasts about 2-3 years, but potentially longer if cared for in the
right way.
· When charging the battery, use dedicated chargers and follow the specified conditions.
· Do not use or charge the battery close to fire or inside a car in which the temperature may exceed
60°C.
· Stop charging the battery if charging is not completed within the specified time.
· Thoroughly read the user's manual for the charger before charging the battery.
· The battery can be charged within a 0°C to 45°C temperature range.
· Use the battery only in the specified equipment.
· Do not charge the battery in a place where static electricity is generated, or let the battery touch
something that is statically charged.
Recycle and Disposal Methods
Lithium ion batteries, like all rechargeable batteries are recyclable and should be recycled.
CAUTION
If your battery is damaged, or if it no longer holds a charge, dispose of it promptly and properly.
Do not dispose of it along with general waste. Call your local waste disposal agency or
environmental agency for advice on disposing of the battery.

Removal and Re-installation of Modules

When your Meazura™ MEZ1000 RDA leaves the factory, the module screws are tightened to a specific
torque setting to ensure the Meazura™ MEZ1000 is sealed to IP67 standards. However if you do
decide to remove and re-insert the module, then to keep the Meazura™ sealed to IP67 standards, the
module screws should be tightened to 40c2nm (or hand tight).
NOTE
Once you have personally removed the module from the Meazura™ MEZ1000 RDA, then your
warranty is voided. You can however request that Aceeca or approved distributors re-insert the
module for you to keep your warranty valid.

Refurbishment Services

Aceeca offers refurbishment services for your RDA. The types of services that exist are;
· Replacement of touchscreen
· Replacement of gaskets and keypad
· Refitting of module
· Refurbishment of damaged exterior
109