Table of Contents
Advertisement
SECTION 4: OPERATIONS
Blade Selection
Always use sharp blades and select the correct
blade for the material being cut. The resulting cut
will be cleaner and there will be less stress on
the machine. Always inspect saw blades closely
before installation, and never use saw blades with
bent or missing teeth, or that appear damaged in
any way.
Blade Requirements:
•
Diameter: 115mm
•
Bore: 22mm
The T10824 Track Saw comes with the following
blades designed to be used with different materi-
als (see Figure 8).
A. Coarse-Tooth Blade: for use with wood and
wood-based material.
B. Diamond Blade: for use with tiles and stone.
C. Abrasive Blade: for use with steel.
D. Fine-Tooth Blade: for use with soft met-
als (aluminum, copper, brass), single-sided
coated sheet materials, and plastics.
A
C
Figure 8. Included blades.
Model T10824 (Mfd. Since 07/14)
B
D
Changing Blades
AMPUTATION HAZARD!
Always unplug power cord
before changing or adjust-
ing blade to avoid severe
injury occur from unex-
pected startup.
To replace blade:
1.
DISCONNECT SAW FROM POWER!
2.
Loosen release screw 4-5 turns (see Figure
9) and allow saw to pivot up for access to
blade.
Release
Screw
Figure 9. Release screw used to open saw
when changing blade.
-17-
Advertisement
Table of Contents
