Grizzly T10824 Owner's Manual page 18

3. With saw in open position, as shown in Figure
10, steady arbor by inserting 24mm spanner
wrench into two holes on outer flange.
Figure 10. Saw in open position for blade
change.
4. With free hand, use 5mm hex wrench to
loosen arbor bolt (see Figure 11).
Figure 11. Removing arbor bolt.
5. Remove arbor bolt, washer, outer flange,
and blade. Make sure inner flange remains
seated on arbor.
-18-
6.
Outer
Flange
Figure 12. Example of proper blade orientation.
7.
Arbor
Bolt
Figure 13. Installation order of blade and related
8.
Slide new blade onto arbor, ensuring that
teeth at bottom of blade face forward, as
shown in Figure 12.
Using spanner wrench and hex wrench,
install outer flange, washer, and arbor bolt,
as shown in Figure 13. The flat side of outer
flange faces AWAY from blade. The indented
side faces TOWARD blade.
Outer
Flange
Dock
Washer
components.
Pivot saw all the way down, then tighten
release screw shown in Figure 9 on Page 17.
Model T10824 (Mfd. Since 07/14)
Arbor
Inner
Flange
Blade