Problems And Warning Signals - ELNA eXcellence 760 Instruction Manual

Problems and Warning Signals

If a buzzer sounds and the LCD screen shows a warning sign, follow the guidance below.
Warning Sign
The foot control is disconnected while sewing.
The start/stop button is pressed with the foot control
connected.
The power is turned on while depressing the foot
control.
The power is turned on with the needle in the down
position.
The machine is started without lowering the presser
foot.
The machine will stop if the presser foot is raised while
sewing.
The bobbin winder spindle is shifted to the right.
The machine will stop if the buttonhole is sewn without
lowering the buttonhole lever.
The foot control is released or the start/stop button is
pressed while sewing a locking stitch.
The auto thread cutter button is pressed while the
machine is still initializing after turning the power on. Or,
the thread cutter button is pressed 4 times in a row.
The twin needle button is pressed when a pattern
unsuitable for twin needle sewing has been selected.
Cause
105
Try this
Connect the foot control
and start the machine
again.
Disconnect the foot control.
Release the foot control.
Turn the hand wheel to
raise the needle.
Lower the presser foot and
start the machine.
Lower the presser foot and
start the machine again.
Shift the bobbin winder
spindle to the left for
stitching.
Lower the buttonhole lever
and start the machine
again.
Start the machine again
to let the machine stop
automatically.
Press the thread cutter
button after the machine
stops.
Select the pattern suitable
for twin needle sewing.