ELNA eXcellence 760 Instruction Manual page 22

z
q
e
w
r
c v
b
t
x
Winding the bobbin
z Pull the thread from the spool.
Hold the thread with both hands and pass the thread
into the guide slot.
q Guide slot
x Draw the thread to the left and forward around the
thread guide.
Draw the thread to the rear and to the right around
under the guide plate.
Firmly pull the thread to the right while holding it with
both hands.
w Thread guide
e Guide plate
c Pass the thread through the hole in the bobbin from
the inside to the outside.
Put the bobbin on the bobbin winder spindle.
Push the bobbin to the right. The bobbin winding
window appears.
r Hole
v Hold the free end of the thread in your hand and start
the machine.
Stop the machine when the bobbin has wound several
layers, and cut the thread close to the hole in the
bobbin.
NOTE:
Set the speed control slider at the fastest position.
b Start the machine again.
Stop the machine when the bobbin is fully wound and
stops spinning.
Return the bobbin winder spindle to its original
position.
Remove the bobbin and cut the thread with the thread
cutter.
t Thread cutter
NOTE:
For safety purposes, the machine will automatically
stop approximately 90 seconds after starting bobbin
winding.
20