ELNA eXcellence 760 Instruction Manual page 108

Warning Sign
The LCD screen shows an
abnormal display.
Audible Signal
pip
pip-pip
pip-pip-pip
peep
pip pi-pi-pi-peep
The elongation key is pressed when a pattern
that cannot be elongated has been selected.
The memory key is pressed when a pattern that
cannot be memorized has been selected.
The startover key is pressed when a pattern that
cannot be started over has been selected.
The vertical mirror image key is pressed when
a pattern that cannot be turned over has been
selected.
The horizontal mirror image key is pressed when
a pattern that cannot be turned over has been
selected.
The machine is started without lowering the feed
dog with basting or button sewing selected.
The machine is started with the feed dog
lowered.
The machine is started without the needle plate.
The machine is started when the needle plate
for straight stitch is attached and a pattern that
cannot be used for the needle plate has been
selected.
The machine is started after halting due to overload.
The feed dog is lowered while the machine is running.
The presser foot is raised while the machine is
running.
The bobbin winder spindle is shifted to the left while
winding a bobbin.
The machine does not work properly due to a
problem in the control circuit.
Turn the power off and turn it on again.
The buzzer sounds when:
Normal operation.
Deleting a pattern combination with the clear key.
Invalid operation or malfunction.
E1-E7 error occurred.
Buttonhole is completed.
Cause
106
Try this
Elongation is applicable only to
satin stitches.
Select a pattern that can
be memorized.
Select a pattern that can
be started over.
Select a pattern that can
be turned over.
Select a pattern that can
be turned over.
Lower the feed dog.
Raise the feed dog.
Attach the needle plate.
Replace the needle plate.
Wait for at least 15 seconds to
restart. Remove tangled threads
around take-up lever, hook race and
automatic thread cutting mechanism.
Do not lower the feed dog, raise
presser foot or shift bobbin winder
spindle while the machine is running.
Contact the service center or the
store from whom the machine
was purchased.