Square (Sensor) Buttonholes - ELNA eXcellence 760 Instruction Manual

q
e
r
z
x
e
c
r
v
t
w
q
w

Square (Sensor) buttonholes

Machine settings
q Pattern:
w Thread tension:
e Presser foot:
r Foot pressure:
Sensor buttonhole
Patterns number 23 and 25 to 33 are sensor buttonholes.
The size of a buttonhole is automatically set by placing a
button in the rear of automatic buttonhole foot R.
The button holder of the foot takes a button size of 1 cm
(3/8˝) to 2.5 cm (1˝) in diameter.
When selecting the sensor buttonholes, the LCD screen
advise you to lower the buttonhole lever.
NOTES:
It is sometimes necessary to change buttonhole size
to match certain heavy or specific fabrics and threads.
Make a test buttonhole on an extra piece of the fabric
to check your settings.
The preset width of the buttonhole is suited for
ordinary buttons.
Apply an interfacing to stretch or fine fabrics.
Sewing
z Press the needle up/down button to raise the needle.
Attach the automatic buttonhole foot R snapping the
pin into the groove of the foot holder.
You may lift the presser foot lifter to the extra lifted
position when placing the automatic buttonhole foot
under the foot holder.
q Groove
w Pin
x Pull the button holder to the back, and place the
button in it. Push it together tightly on the button.
e Button holder
c Pull the buttonhole lever down as far as it will go.
r Buttonhole lever
v Mark the buttonhole position on the fabric and place
it under the buttonhole foot. Lower the needle at the
starting point by turning the hand wheel.
t Starting point
55
23
AUTO
Automatic buttonhole foot R
5