Craftsman 152.221240 Owner's Manual page 22

KNOB AND CURSOR ASSEMBLY
Figure 11-9
D
C
B
A
1. Thread knob (A) onto fence locking handle (B).
Turn knob clockwise to screw it onto threads of
fence locking handle. See figure 11-9.
2. Align left fence side (C) at a distance from the right
side (D) of the right miter gauge groove and lock
the fence.
3. Use a measuring tape to measure the distance
from the saw blade right side to the left fence side.
4. Assemble the cursor (E) to the right side of the
fence cross arm (F) with two #10-32 x 3/8" round
head screws and #10 flat washers (I). Do not
completely tighten screws.
5. Align cursor with the guide tube measuring scale
(H) so that the thin black line (G) is on the same
number as the distance measured in Step 3.
Tighten the cursor screws.
6. Remove fence from table and reposition it on left
side of saw blade. Align right fence side at a dis-
tance from the left side of left miter gauge groove
and lock the fence.
7. Use a measuring tape to measure the distance
from the saw blade left side to the right fence side.
8. Assemble the second cursor to left side of fence
cross arm with two #10-32 x 3/8" round head
screws and #10 flat washers. Do not completely
tighten screws.
9. Align cursor with the guide tube measuring scale so
that the thin black line is on the same number as
the distance measured in Step 7. Tighten the cursor
screws.
I
F
G
E
H
OUTFEED TABLE ASSEMBLY
Figure 11-10
I
E
D
C
G
A
1. Attach support retainer (A) to the lower rear of the
cabinet with two M6 x 25mm hex head screws, M6
lock washers and M6 flat washers. Do not com-
pletely tighten hardware. See figure 11-10.
2. Assemble the lower support (B) to the support
retainer with one M6 x 35mm hex head screw and
M6 Nylok hex nut. Be sure that the notch (H) in the
lower support is facing up. Do not completely tight-
en hex nut. Allow lower support to move freely.
See Figure 11-10 and 11-11.
Figure 11-11
E
3. Place clamp knob (C) through slot (D) of upper sup-
port assembly (E), making sure that the rounded
corner (M) of the upper support is facing towards
notch (H) in lower support. Thread clamp knob into
threaded hole of lower support.
22
K
I
F
H
B
C
H
B
K
J
G
D
M