Training; Hazard Warnings - Harsco Industrial SC-2000 Installation & Owner's Manual

N !
OTICE
The safety labels shown below are
affixed to your boiler. Although the
labels are of high quality, they may
become dislodged or unreadable
over time. Contact Harsco
Industrial, Patterson-Kelley at
570.476.7261 or toll-free at
877.728.5351 for replacements.
Gas may lose its odor. Proper gas
sensing equipment and procedures
should be used for leak checks.
Failure to detect gas leaks could
result in injury or death.
2.4.4 Pressure Hazards
Pressure Hazard! Hot fluids. Install isolation valves on boiler water inlet and outlet. Make sure
isolation valves are closed before servicing boiler.
Pressure Hazard! Hot fluids. Annually test safety relief valve(s) for proper operation. Do not operate
boiler with faulty relief valve(s).
Harsco Industrial, Patterson-Kelley Technical Service 1.877.728.5351

2.3 Training

Proper training is the best protection against accidents. It is
essential to read, understand, and follow the recommendations of
this manual before installing, operating, or servicing this
equipment. Failure to do so could result in fire or explosion and
serious injury, death, and/or property damage.
Operating and service personnel must be thoroughly familiar with
the basic construction of the SC-2000,
boilers, the use and locations of the controls, the operation of the
boilers, adjustment of their various mechanisms, and all applicable
safety precautions. If any of the provisions of this manual are not
fully and completely understood, contact Harsco Industrial,
Patterson-Kelley Technical Service at
877.728.5351.

2.4 Hazard Warnings

2.4.1 Electrical Hazards
2.4.2 Crush Hazards
2.4.3 Bump Hazard from Overhead Ductwork and Piping
Shock Hazard! Properly lockout/tagout the electrical
service and all other energy sources before working on
or near the boiler.
Shock Hazard! Do not spray water directly on this
boiler or any electrical components.
Electrical Hazard! Do not alter wiring connections.
Lifting Hazards! Use properly rated lifting equipment
to lift and position the boiler. The load is unbalanced.
Test the balance before lifting off the floor. Do not
allow personnel beneath the lifted load. Refer to the
approximate weights in the table.
Boiler Model
SC-2000
SC-3000
SC-4000
Injury Hazard! Install components with adequate
vertical clearance.
9
Gas Fired Boiler
and
SC-3000 SC-4000
or toll free at
570.476.7261
Weight in Pounds
1,450 lbs
1,850 lbs
1,900 lbs