Chapter 11: System Board Jumper - PIONEERPOS StealthTouch M5 User Manual

Chapter 11: System Board Jumper

(Highlighted item indicates factory default setting)
WARNING:
This section is written for TECHNICALLY QUALIFIED PERSONNEL ONLY. Modifying jumper setting to other than
manufacturer default setting may result in damages of device. PioneerPOS will not be responsible for loss and
damages on StealthTouch terminal and any other devices due to user modification. Call 909-468-9757 or email
support@pioneerpos.com
J1: LCD voltage setting
Connector: HEADER 1X3P,S/T,2.0mm,DIP
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
1-2 5V
2-3 3V
J2: INVERTER voltage SEL
Connector: HEADER 1X3P,S/T,2.0mm,DIP
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
1-2 12V
2-3 5V
J3: INVERTER control SEL
Connector: HEADER 1X3P,S/T,2.0mm,DIP
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
1-2 DC control
2-3 PWM control
CLRTC
Connector: HEADER 1X3P G/F S/T 2.54MM CHARL
Jumper: MINI JUMPER 2P 2.54MM CLOSE C-S
1-2 Normal
2-3 Clear CMOS
KB2: KB/MS signal by pass to KB1
Connector: HEADER 2X3P S/T,2.54MM,DIP
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
1-2 KB2
3-4 KB2
COM2_DCD: COM2 DCD Jump setting
Connector: HEADER 2X3P G/F 2.0MM BLK S/T
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
1-2 12V
3-4 5V
5-6 DCD
Manual for StealthTouch M5-M7 with Core Pentium & Core i-Series Model v1.0
for help.
(default)
(default)
(default)
(default)
(default)
Settings
Pin 1
Pin 1
Pin 1
Pin 1
Pin 1
Pin 1
Pin 2
Page 31