Chapter 11: System Board Jumper Settings - PIONEERPOS CYPRUS User Manual

Chapter 11: System Board jumper settings

WARNING:
This section is written for TECHNICALLY QUALIFIED PERSONNEL ONLY. Modifying jumper setting to other than
manufacturer default setting may result in damages of device. Damages due to customer modification will VOID
factory warranty on motherboard and CYPRUS terminal. PioneerPOS will not be responsible for loss and
damages on Cyprus terminal and any other devices due to user modification. Call 909-468-9757 option 2 or email
support@pioneerpos.com
Factory default setting is indicated with marking: (default)
JP3: LVDS LCD Power Select
JP3 LVDS Power
1-2 3.3V (default)
2-3 5V
JP4: LED and CCFL Inverter Select
JP4 LVDS Power
1-2 CCFL Inverter (default)
2-3 LED Inverter
JP9: COM 6 Power Select
JP9 COM 6 Power Select
1-2 +3.3V (default)
2-3 DCD
JP13: COM 2 RI Pin Select
JP13 COM 2 RI Pin Select
1-2 Ring
2-3 GND(default)
JP14: COM 2 Power Select
JP14 COM 2 DCD Pin (Pin 1)
1-3 +5V
3-5 +12V
7-9 DCD (default)
Note: The setting will not affect the I-COM2
JP17: Panel Type Selection for LVDS
JP17 Boot Display Device
1-2 3-4 Boot Display Device
Short Short N/A
Open Short LCD
Short Open CRT
Open Open LCD+CRT (default)
JP17 Panel Type Setting
5-6 7-8 Boot Resolution Select
Short Short 1440 x900 / 1920 x 1080 (CH7511)
Short Open 1280 x 1024
Open Short 1024 x 768 (default)
Open Open 800 x 600
Manual for CYPRUS (V1.0) (Atom Dual Core)
for help.
JP14 COM 2 RI Pin (Pin 5)
2-4 +5V
4-6 +12V
8-10 RI (default)
Page 27