Section B: Using Stealthtouch-M5/M7 System; Chapter 3: Touch Screen Panel - PIONEERPOS StealthTouch M5 User Manual

Section B: Using StealthTouch-
M5/M7 system

Chapter 3: Touch screen panel

[Note] The instructions below ONLY apply for Resistive Type Touch Panel under Windows 7 operating system. For
Resistive panel under Windows 8, see GUI-PUB-054. For PCAT type touch panel, it will not require calibration for either
Windows 7 or Windows 8 OS.
StealthTouth-M5/M7's Touch Screen can be operated with finger or soft stylus. If you have re-installed the driver software,
you need to open TouchKit to re-calibrate the touch screen:
1. Go to Start -> All Programs -> eGalaxTouch -> Configure Utility.
Click on "Tools" when you need to calibrate.
2.
3. Perform 4 point calibration when you see the calibration screen. Use a touch screen stylus pen or your finger to
touch each point for about 1-2 seconds until you hear a "beep" sound.
[Note] Linearization is not needed for regular use.
Picture: 4 point calibration screen
Manual for StealthTouch M5-M7 with Core Pentium & Core i-Series Model v1.0 Page 15