[Remote Control]; Network Information; [Factory Default] - Panasonic PJLink PT-LW330 Operating Instructions Manual

[Network information]

1) Press as to select [Network].
2) Press the <ENTER> button.
f The [Network] screen is displayed and then confirm the following items.
[MAC address]
[IP address]

[Remote control]

This switching function prevents remote control interference when operating several projectors or video equipment at the same
time.
1) Press as to select [Remote control].
2) Press the <ENTER> button.
f The [Remote control] screen is displayed.
3) Press as to select one item.
f This projector provides 7 different remote control codes: [All], [Code 1]~[Code 6].
[All]
[Code 1] - [Code 6] Select when specifying an ID number to control individual projector.
4) Press the <ENTER> button.
f [Remote control] is set.
Note
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [All], the projector will operate regardless of the ID number specified by remote control. If
multiple projectors are set up side by side with ID set to [All], they cannot be controlled separately from the projectors with
other ID numbers.
f Refer to "Setting Remote control ID numbers" (x page 23) for how to set the ID number on the remote control.

[Factory default]

Return various setting values to their factory default settings.
1) Press as to select [Factory default].
2) Press the <ENTER> button.
f The [Return to Factory default?] screen is displayed.
3) Press as to select [Yes] and then press the <ENTER> button.
f The [OK?] screen is displayed.
4) Press as to select [Yes] and then press the <ENTER> button.
f The [Please wait...] message will appear, and resetting operation will start, and after completing the operation, the
[Please wait...] message will disappear.
Attention
f After executing the [Factory default], be sure to turn off the projector (x page 36), disconnect the power plug from the wall
outlet, and then turn on the projector in order to reflect the initial setting values.
Note
f When [Factory default] is executed, all setting values except for User Logo, PIN code lock, Logo PIN code lock, Lamp
counter, Filter counter and Logo select to the factory default settings.
70 - ENGLISH
Chapter 4 Settings - [Expand] menu
Displays the MAC address of this projector.
Displays the current IP address of this projector.
Select when controlling projectors without specifying an ID number.