Panasonic PJLink PT-LW330 Operating Instructions Manual page 22

3 <COMPUTER 1 IN> terminal
This is the terminal to input RGB, YP
S-video signals.
4 <COMPUTER 2 IN/ 1 OUT> terminal
This is the terminal to input RGB signals or output the
RGB signals to external monitor.
5 <HDMI IN> terminal
This is the terminal to input HDMI signals.
6 <LAN> terminal
This is the LAN terminal to connect to the network.
7 <USB B (DISPLAY)> terminal
This terminal is used to connect the projector to the
computer with a USB cable when you want to use the
USB Display function.
8 <USB A (VIEWER)> terminal
When using the Memory Viewer function, insert the USB
memory directly to this terminal.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
r Only for PT-LB300 and PT-LB280
1 2
7
1 <VARIABLE AUDIO OUT> terminal
This is the terminal to output audio signal input to the
projector.
2 <VIDEO IN> terminal
This is the terminal to input video signals.
3 <COMPUTER 1 IN> terminal
This is the terminal to input RGB, YP
S-video signals.
4 <MONITOR OUT> terminal
This is the terminal to output the RGB signals to external
monitor.
5 <HDMI IN> terminal
This is the terminal to input HDMI signals.
6 <USB B> terminal
For service use.
22 - ENGLISH
Chapter 1 Preparation - About your projector
P /YC C or
B R B R
3
8
9
P /YC C or
B R B R
9 <AUDIO IN 1> terminal
This is the terminal to input computer audio signals.
In addition, if you have set [HDMI setup] → [Sound]
to [Computer], it outputs the analog audio of the input
signal which is input to <AUDIO IN 1> terminal when the
HDMI input source is selected.
10 <AUDIO IN 2 (L/R)> terminal
This is the terminal to input Video, S-video and YC
YP P audio signals.
B R
There are a left (L) terminal and a right (R) terminal.
11 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally
control the projector by connecting a computer.
4 5
7 <AUDIO IN 1> terminal
This is the terminal to input computer audio signals.
In addition, if you have set [HDMI setup] → [Sound] to
[Computer], it outputs the analog audio of the input signal
which is input to <AUDIO IN 1> terminal when the HDMI
input source is selected.
8 <AUDIO IN 2 (L/R)> terminal
This is the terminal to input Video, S-video and YC
YP P audio signals.
B R
There are a left (L) terminal and a right (R) terminal.
9 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally
control the projector by connecting a computer.
C /
B R
6
C /
B R