Projector Body - Panasonic PJLink PT-LW330 Operating Instructions Manual

Note
f The remote control can be used within a distance of about 5 m (16'4-13/16") if pointed directly at the remote control signal
receiver. The remote control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control
range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not
operate correctly.
f You can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to
the loss of light caused by the properties of the screen.
f When the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become
inoperative. Set the projector as far from the luminous source as possible.

Projector body

1
Top
5
4
Side
7
Side
10
Projection direction
WARNING
Keep your hands and other objects away from the air exhaust port.
f Keep your hand and face away.
f Do not insert your finger.
f Keep heat-sensitive articles away.
Heated air from the air exhaust port can cause burns or external damage.
1 Control Panel and Indicators (x page 21)
2 Lamp cover (x page 89)
The lamp unit is located inside.
3 Security Chain Hook
Attaches a burglar prevention cable, etc.
4 Focus ring (Front)
Adjust the focus.
20 - ENGLISH
Chapter 1 Preparation - About your projector
2
Bottom
Front
8
Rear
11
3
6
6
9
12 3 13
5 Zoom ring (Back)
Adjust the zoom.
6 Adjustable foot
Adjust the projection angle.
7 Air intake port / Air filter cover (x page 86)
The air filter unit is inside.
8 Remote control signal receiver
14