[Key Lock]; [Iris]; [Terminal]; [Sound] - Panasonic PJLink PT-LW330 Operating Instructions Manual

f [Closed caption] can only be selected if an NTSC signal is input.
f If [Closed caption] is set to the item except for [Off], the brightness of image may be changed according to the external
devices or the used content of the closed caption corresponding connection.
f Closed captions are not displayed when the menu screen is displayed.

[Key lock]

Enable/disable the button operations on the control panel and the remote control.
1) Press as to select [Key lock].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[ (Off)]
[ (Projector)]
(Remote control)] Disables the button operations on the remote control.
[

[Iris]

Aperture correction and signal compensation are performed automatically based on the image to result in an image of
optimum contrast.
1) Press as to select [Iris].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[On]
[Off]

[Terminal]

(Only for PT-LW330, PT-LW280, PT-LB360 and PT-LB330)
The <COMPUTER 2 IN/1 OUT> terminal on the back of the projector is switchable for computer 2 input or monitor output.
1) Press as to select [Terminal].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Monitor out]
[Computer 2]
Note
f The [Terminal] will be unavailable when [Computer 2] is selected as input source.

[Sound]

You can perform more detailed setting for Audio.

Adjusting the volume

1) Press as to select [Sound].
2) Press the <ENTER> button.
f The [Sound] screen is displayed.
3) Press as to select [Volume].
4) Press the <ENTER> button.
5) Press as to adjust the level.
f You can also press the <VOLUME +/-> button on the remote control. (x page 41)
Chapter 4 Settings - [Setting] menu
Enables the button operations on the control panel or the remote control.
Disables the button operations on the control panel.
Corrects the aperture.
No aperture correction.
Outputs the RGB signal which have been input <COMPUTER 1 IN> terminal.
When input the computer signal.
ENGLISH - 57