[V Position]; [H.size]; [Aspect] - Panasonic PJLink PT-LW330 Operating Instructions Manual

Orientation
Horizontal (left and
right) adjustment.
Note
f [H Position] is not available while the image is expanded in the digital zoom function.

[V Position]

(Only for computer signals input)
Move the image position vertically if the image position projected on the screen is shifted even when the relative position of the
projector and the screen is installed correctly.
1) Press as to select [V Position].
2) Press the <ENTER> button.
3) Press as to adjust the vertical image position.
Orientation
Vertical (up and down)
adjustment.
Note
f [V Position] is not available while the image is expanded in the digital zoom function.

[H.Size]

(Only for computer signals input)
Use this function to adjust and minimize the effect of interference caused by projection of patterns consisting of vertical stripes.
The projection of the vertical striped pattern may cause cyclic patterns (noise). Adjust so that the amount of interference is at a
minimum.
1) Press as to select [H.Size].
2) Press the <ENTER> button.
3) Press as to adjust the level.
f The adjustment values are -15 to +15.
Attention
fSet it before adjusting [Fine sync].

[Aspect]

Provide the image to fit the screen size while maintaining the aspect ratio of the input signal.
1) Press as to select [Aspect].
2) Press the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Normal]
[Wide]
50 - ENGLISH
Chapter 4 Settings - [Display] menu
Operation
Press the a button. The image position moves to the right.
Press the s button. The image position moves to the left.
Operation
Press the a button. The image position moves up.
Press the s button. The image position moves down.
Projects the image at the maximum size while maintaining the aspect ratio of the input signal.
Projects the image at 16:9 aspect ratio.
Adjustment
Adjustment