Panasonic AW-HE130W Operating Instructions Manual page 84

Web screen configurations (continued)
System screen
„
This menu has items that relate to the genlock phase adjustment and
camera's output image settings.
z Genlock
This item's setting is reflected immediately.
Horizontal Phase
This is used to adjust the horizontal phase during genlock.
Setting range: -206 to +49
<NOTE>
• The horizontal phases of the HD and SD signals cannot be adjusted
separately.
Neither is it possible to adjust the chroma phase of the VIDEO OUT
signals. The free run setting is used.
84
z Output
This item's setting is reflected when the Set button is pressed.
Format
The video format is changed on this screen.
For 480/59.94p(i) and 576/50p(i), P signals are output for HDMI, while
I signals are output for SDI and analog component outputs.
Setting value:
For 59.94Hz:
1080/59.94p, 1080/29.97p, 1080/23.98p, 1080/59.94i,
1080/29.97PsF, 1080/23.98PsF, 720/59.94p, 480/59.94p(i)
For 50Hz:
1080/50p, 1080/25p, 1080/50i, 180/25PsF, 720/50p, 576/50p(i)
<NOTE>
• When you switch from an HD format to an SD format or vice versa,
the unit automatically restarts after the Format Set screen appears.
Down CONV. Mode
The down-conversion mode is selected here.
Setting value:
Use this when the aspect ratio of the monitor is 16:9.
When the 4:3 aspect ratio has been set for the monitor
screen, the images are squeezed horizontally and
extended vertically changing the view of the angle.
Squeeze
Use this when the aspect ratio of the monitor is 4:3. With
the vertical height serving as the reference, the parts
which extend beyond this at the two sides are cropped
changing the view of the angle.
SideCut
Use this when the aspect ratio of the monitor is 4:3. With
the horizontal width serving as the reference, black bands
are added at the top and bottom changing the view of the
angle.
LetterBox
HDMI Color
Set here is the HDMI color output.
RGB-NOR / RGB-ENH / YCbCr422 / YCbCr444
• When an HDMI monitor is used, use "YCbCr422" under normal
circumstances.
• In cases where, for instance, HDMI (RGB) signals are converted
and output to a DVI monitor, the settings required will differ
depending on the color gradation supported by the monitor.
The RGB output signals are output in the 16 to 235
RGB-NOR
range.
The RGB output signals are output in the 0 to 255
RGB-ENH
range.
• If the black parts of the images appear overexposed when "RGB-
NOR" has been selected, use the "RGB-ENH" setting instead.
• Conversely, if the images are displayed with a loss of dark detail
when "RGB-ENH" has been selected, use the "RGB-NOR" setting
instead.
<NOTE>
• If an HDMI Color setting which is not supported by the monitor
has been specified, the HDMI Color setting may be changed
automatically. (The menu display will remain unchanged.)