Table 64 Menu 3.2: Lan Tcp/Ip Setup Fields - ZyXEL Communications Prestige 2302R User Manual

Table 63 DHCP Ethernet Setup Fields (continued)
FIELD
First DNS Server
Second DNS
Server
Third DNS Server
DHCP Server
Address
Use the instructions in the following table to configure TCP/IP parameters for the LAN port.

Table 64 Menu 3.2: LAN TCP/IP Setup Fields

FIELD
TCP/IP Setup:
IP Address
IP Subnet Mask
RIP Direction
Version
Multicast
Edit IP Alias
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm...] to
save your configuration, or press [ESC] at any time to cancel.
Chapter 19 Menu 3 LAN Setup
DESCRIPTION
The Prestige passes a DNS (Domain Name System) server IP address (in the order
you specify here) to the DHCP clients.
Select From ISP if your ISP dynamically assigns DNS server information (and the
Prestige's WAN IP address). The IP Address field below displays the (read-only)
DNS server IP address that the ISP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the DNS
server's IP address in the IP Address field below. If you chose User-Defined, but
leave the IP address set to 0.0.0.0, User-Defined changes to None after you save
your changes. If you set a second choice to User-Defined, and enter the same IP
address, the second User-Defined changes to None after you save your changes.
Select DNS Relay to have the Prestige act as a DNS proxy. The Prestige's LAN IP
address displays in the IP Address field below (read-only). The Prestige tells the
DHCP clients on the LAN that the Prestige itself is the DNS server. When a
computer on the LAN sends a DNS query to the Prestige, the Prestige forwards the
query to the Prestige's system DNS server (configured in menu 1) and relays the
response back to the computer. You can only select DNS Relay for one of the three
servers; if you select DNS Relay for a second or third DNS server, that choice
changes to None after you save your changes.
Select None if you do not want to configure DNS servers. If you do not configure a
DNS server, you must know the IP address of a machine in order to access it.
If Relay is selected in the DHCP field above, then type the IP address of the actual,
remote DHCP server here.
DESCRIPTION
Enter the IP address of your Prestige in dotted decimal notation
Your Prestige will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the
subnet mask computed by the Prestige.
Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options are:
Both, In Only, Out Only or None.
Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are:
RIP-1, RIP-2B or RIP-2M.
IGMP (Internet Group Multicast Protocol) is a session-layer protocol used to
establish membership in a Multicast group. The Prestige supports both IGMP
version 1 (IGMP-v1) and version 2 (IGMP-v2). Press [SPACE BAR] and then
[ENTER] to enable IP Multicasting or select None (default) to disable it.
The Prestige supports three logical LAN interfaces via its single physical
Ethernet interface with the Prestige itself as the gateway for each LAN network.
Press [SPACE BAR] to select Yes and then press [ENTER] to display menu
3.2.1
Prestige 2302R Series User's Guide
185