Country Code Selection; De-Commissioning - Mastervolt Sunmaster XS4300 User And Installation Manual

4.3.2

Country code selection

Follow the steps below to configure the Sunmaster in
accordance with the local regulations for grid connection
(example: Italy).
CAUTION!
NEVER connect the Sunmaster to a utility grid
other than selected.
1 After commissioning
displayed.
S1
S3
2 Select the applicable country code from the table
below.
Country code Norm
GERMANY 1P, ENS
limited to 4.600 W
GERMANY 3P ENS
SPAIN QNS
ITALY ENS
UK QNS
FRANCE ENS
AUSTRALIA QNS
GREECE QNS
HOLLAND QNS
USA 240V QNS
USA 208V QNS
KOREA QNS
TAIWAN QNS
3 Press S4 to scroll through the country codes.
4 If the correct country code is shown, press S2 to
select
EN / Sunmaster XS4300-3200-2000 / November 2008
the following message
S2
S4
Press S4 to scroll through
the country codes
Use Allowed in
Germany, Austria, Belgium
Germany, Austria, Belgium
Spain
Italy
United Kingdom
France
Australia
Greece
Netherlands, rest of
Europe
USA
(Split Phase 240V)
USA
(ThreePhase 208V)
South Korea
Taiwan
S1
is
S3
5 Confirm your selection by pressing S3 (or cancel by
pressing S4).
S1
S3
Press S3 to confirm
the selection
If a wrong country code was entered, you can
start the procedure over again by pressing S2
and S4 simultaneously during 3 seconds.
6 Now the Sunmaster switches on. See chapter 0 for
operation instructions.
4.4

DE-COMMISSIONING

If it is necessary to de-commission the Sunmaster, follow
the instructions in order of succession as described below:
CAUTION!
Follow below mentioned instructions in order
of succession as described.
1 Cut off the grid voltage by switching off AC distribution
switch in the meter cupboard.
2 If such is applied, move the DC switch to the OFF-
position.
3 Disconnect the MultiContact connectors from the
Sunmaster.
4 Remove the bottom plate of the Sunmaster and
disconnect the AC wiring.
Now the Sunmaster can be demounted in a safe way.
INSTALLATION
Press S2 to select the
displayed country code
S2
S4
Press S4 to scroll through
the country codes
S2
S4
Press S4 to cancel
the selection
13