Flexible Interface Module Setup - Allen-Bradley 2755-LS7-SB User Manual

Flexible Interface Module Setup

You need to configure the flexible interface module. Follow the
steps below or refer to the Flexible Interface Module User Manual
(Publication No. 2760-ND001) or the SFC1 or SFC2 Protocol
Cartridge User Manuals (Publication Nos. 2760-ND002 or
2760-822).
1. Select 90B to reset the configuration to factory defaults.
2. Configure screens 3, 21, and 11 (in this order) as shown starting
below.
2760–RB SERIES A REVISION J
COPYRIGHT 1989
––––––––––––––––––––––––––––––––––––––––––––––––––––
1X – CONFIGURATION PARAMETERS
3 – DEVICE PORT PROTOCOL NAMES
5I – DISCRETE BYTE INPUT ENTRIES
7 – THE PASS THROUGH ENTRIES
9XF – RB MODULE FUNCTIONS
BX – SOFTWARE DIAGNOSTICS
WHERE X (0 TO 7) AND D (1 TO 3) ARE PORT NUMBERS WHICH ARE DEFINED BELOW :
0 – RB CMMND PRCSS 2 – SERIAL PORT 2 4 – CONFIG PORT
1 – SERIAL PORT 1 3 – SERIAL PORT 3 5 – I/O RACK SLT 0 7 – RESERVED
WHERE F (A TO E) ARE FUNCTIONS THAT RB CAN PERFORM WHICH ARE DEFINED BELOW :
A – RESET B – SET DEFAULTS C – FLUSH D – INITIALIZE E – CLEAR DIAGS
WHERE M (A TO T) AND I (A TO H) ARE ENTRY NUMBERS FOR THE SELECTION MADE ABOVE.
ENTER A MAIN MENU SELECTION:
ENTER A MAIN MENU SELECTION: 3
PORT 1 = COPYRIGHT 1989
2760–SFC1 DT , SERIES A , REVISION B (YES/NO) = YES.
PORT 2 = COPYRIGHT 1989
2760–SFC1 DT , SERIES A , REVISION B (YES/NO) = YES.
PORT 3 = COPYRIGHT 1989
2760–SFC1 DT , SERIES A , REVISION B (YES/NO) = YES.
EDIT THIS SELECTION (YES/NO) ?
Application Examples
ALLEN–BRADLEY COMPANY, INC.
2X – IDENTIFICATION NUMBERS
4DM – MATCH CODE ENTRIES
6 – THE DATA MATRIX ENTRIES
8 – NON–VOLATILE SCRATCH PAD AREA
AX – HARDWARE DIAGNOSTICS
C – EXIT CONFIGURATION MODE
6 – I/O RACK SLT 1
ALLEN–BRADLEY COMPANY, INC.
ALLEN–BRADLEY COMPANY, INC.
ALLEN–BRADLEY COMPANY, INC.
E–5
Publication 2755-6.9