Storage' Control Of Lithium Battery; Discharging Lithium Battery - Skyrc 6x80Plus Instruction Manual

LITHIUM BATTERY(LiPo/LiFe/LiIon)PROGRAM
identical you can start charging process. If
not, press button to go back to previous
Press
screen to recheck the number of cells of the
Dial
battery pack before going ahead.
This screen shows the real-time status
during charge process. Press button once to
Current stop the charge process.
Supplied
Charging
voltage
Number
capacity
time
battery
of
Charge
cells
current

'STORAGE' CONTROL OF LITHIUM BATTERY

This program is for charging or discharging Lithium battery which will
not be used for long time. The program will determine to charge or
discharge the battery to certain voltage depending on the voltage of the
battery at its initial stage. They are different from the type of the battery,
3.75V for LiIo, 3.85V for LiPo and 3.3V for LiFe per cell. If the voltage
of battery at its initial stage is over the voltage level to storage, the
program will start to discharge.
At this screen, you can set up the current
and voltage of the battery pack. Charging
and discharging will make the batteries
- + - +
come to the voltage level of storage state.
SELECT SELECT
Press
Mode
> 3 seconds
This screen displays the number of cells you
Dial
Stop
set up and the processor detects. R shows
the number of cells detected by the charger
and S is the number of cells set by you at
the previous screen. If both numbers are
identical you can start charging process. If
not, press Mode/Stop button to go back to
18
Number
of
cells

DISCHARGING LITHIUM BATTERY

SELECT
Number
of
cells
6X80 Plus 6X80 Plus
LITHIUM BATTERY(LiPo/LiFe/LiIon)PROGRAM
previous screen to recheck the number of
cells of the battery pack before going ahead.
Press
Dial
This screen shows the real-time status
charging. Press Mode/Stop button once to
stop the charge process.
Current
Supplied
Elapsed
voltage
capacity
time
battery
Charge
or discharge
current
The value of discharge current on the left
can not exceed 1C, and the value on the
right can not be under the voltage
- - +
+
recommended by the manufacturer to avoid
SELECT
over discharging. Press and hold the dial for
Mode Press
> 3 seconds
3 seconds to start discharging.
Stop Dial
This screen displays the number of cells you
set up and the processor detects. R shows
the number of cells detected by the charger
and S is the number of cells set by you at
the previous screen. If both numbers are
identical you can start charging process. If
Press
Dial
not, press Mode/Stop button to go back to
previous screen to recheck the number of
cells of the battery pack before going ahead.
This screen shows the real-time status of
discharging, you can press Mode/Stop
button to stop discharging.
Discharged
elapsed
Battery
capacity
time
voltage
discharge
current
19